PROGRAMMING V2 LI-ION MOTORS (Bi-Directional 2018 - Current)
Single directional devices can be identified by the model number of your remote control or motors.
- MO25LI/S-1.1/40
- DD1802H
PAIRING YOUR REMOTE
- If you are using a multi-channel remote you need to pair the remote to your select channel you wish the blind to respond too.
- Press button on motor head for until motor jogs (2 seconds).
- Press & hold "Stop" until the motor jogs.
- Proceed to the next step
CHECKING AND/OR CHANGING DIRECTION
- Move the blind with the up & down buttons on the remote to identify if the motor is set to the correct direction.
- If the blind is operating correctly move the the next step.
- To change the direction hold "UP & DOWN" for 2 seconds until the blind jogs.
- Test the blinds direction & move onto the next step.
SETTING THE LIMITS
-
Setting the top limit first - Move the blinds to the desired
top position. - Hold "Stop & Up" simultaneously for 2 seconds. The motors will beep 3 time to indicate the limit is set.
-
Setting the top bottom limit - Move the blinds to the desired bottom position.
- Hold "Stop & Down" simultaneously for 2 seconds. The motors will beep 3 time to indicate the limit is set.
- Your motor is now programmed
CHARGING YOUR MOTOR
- Your motor needs to be charged about every 400 movements in normal conditions
- When the motor start to run low they begin to beep whilst in motion to tell you to that it requires charging. You may also notice the blind not being as responsive to you commands.
- Simply plug your charger in the motor head and with wall power. You should notice the light on the charger go red whilst the motors charges. It should take about up to 6 hours for the motor to fully charge. The light l will go green as an indicator to show it is charged.
